Basslink/Basslink X
TROUBLESHOOTING
? PROBLEM:APPLICABLE TO BASSLINK WITH LEVEL
POWER LED not lit.CONTROL JACK AND BASSLINK X ONLY:
CAUSES and SOLUTIONS:
1. Fuse is blown and needs replacement.
2. Head unit not functioning properly. Check? PROBLEM:
remote voltage, and power, ground orBassLink turns on before head unit is completely on
remote connections.and produces a ?thump? sound.
? PROBLEM:CAUSE and SOLUTION:
POWER LED is lit but there is no bass.For speaker-level connections, head unit is
producing a false turn-on signal. On BassLink?s
CAUSES and SOLUTIONS:side panel, slide AUTO TURN-ON to OFF.
1. Inputs are not connected. Check connections.
2. Head-unit fader control is not set properly.? PROBLEM:
Adjust head-unit fader control to feed audioBassLink?s POWER LED remains on after head
signals to BassLink.unit is turned off.
? PROBLEM:CAUSE and SOLUTION:
BassLink sounds muddy or distorted.For speaker-level connections, this is normal
operation when AUTO TURN-ON is set to ON.
BassLink will remain on another 5 to 10 minutes
CAUSES and SOLUTIONS:after sensing that audio signals are not present
1. Gain is set too high and SERVO LED is litbefore shutting down. If you prefer immediate shut-
constantly. Readjust GAIN control (seedown, set AUTO TURN-OFF to OFF.
Tuning BassLink on the previous page).
2. Bass is set too high. Readjust BASS BOOST
control (see Tuning BassLink on the previous
page).
3. Head-unit output is distorted or blown. See
your authorized Infinity car audio dealer.
? PROBLEM:
No output from BassLink when head-unit
fader control set to front or rear (in a 4-channel
connection).
CAUSE and SOLUTION:
Input connections are improperly wired. Verify all
connections (see Applications section) |